Thank you for visiting “mtihotak-53″! We value the following! Careful packaging? Sincere customer service. For that reason, we ask for your understanding and cooperation in the listing of this product. The exterior case is a two-tone color that makes use of the wood grain, with a similar color oil stain and varnish applied. The dust cover on the dial part has been painted on the back, so the dial pointer / dial / pilot light cannot be seen well, and the back cover is missing. There are some signs of use due to the passage of time, but scratches and scuffs have been masked and repainted, the speaker cloth (cloth) has been renewed and replaced, and the three dials and knobs that were originally there are still there, so it is in good condition. The vacuum tubes used are “UZ-57 / UY-27 / UX-12A / KX-12F”, which are now vintage ST tubes, total of four, and the speaker’s voltage coil was broken, so I replaced it with an equivalent one I had on hand. The dial operation is “power switch / for main variable capacitor / for playback variable capacitor” from the left. Other major restoration work included: replacing the power cord, pilot lamp cord, and speaker cord for safety reasons; the electrolytic capacitor was not acceptable, so removed it and installed relay lugs in the empty space and replaced it with new “22? F 250V x 2, 33? F 50V x 2″ to restore it to its original condition; the resistor in the cathode circuit of the output tube was broken, so I used a 1K? Resistor I had on hand to restore it to its original condition; one of the lead wires inside the mica capacitor attached to the first grid of the high frequency amplifier tube was broken, so I replaced this; there was a play that could not be repaired in the restored variable capacitor, so I replaced it with one I had on hand to restore it to its original condition; the variable capacitor shaft was a little loose, so I tightened the adjustment bolt to restore it to its original condition; oil maintenance was performed on each rotating part of the variable capacitor, etc. 2-3 solder joints had come loose, so this was repaired; there was an “input terminal for the PU” on the back of the chassis, so although it is shared with the radio circuit, an external input cord was installed; the coating of each wiring was in poor condition, so It has been restored to its original condition by inserting new insulating coating material, etc. And is now fully functional. The inside of the chassis has also been cleaned, and the output sensitivity of the “external input PU function” is also good. By the way, the size is width 36cm / height 24.5cm / total depth 20.5cm, and the weight is about 4kg. Please check the photos and feel free to ask me any questions you may have. We cannot change an address after the order has already been placed. Envelope, Box or PAK Packing. Small items will be placed in a packing bag whenever possible, but depending on. The shape and size of the item, they may only be packaged in bubble wrapping. Thank you for your understanding. We provide valid Tracking Numbers for all orders. We do not sell to countries where the GPSR act applies (Such as EU countries). If you have any questions or issues, we are at your service. I ask that you send me photos of the product before returning it. I will then compare it with the photo of the product. We can’t not reply gifts or unreasonable requests such as declared amount.