This is a 6tube, wooden table model radio with a self-contained loop antenna. The radio measures 15.5″ wide x 9.5″ high x 8.5 deep. A Bluetooth receiver was wired inside the radio and is activated through a switch on the back of the radio. Electronically, the chassis has been completely cleaned and brand new electrolytic capacitorsinstalled. Tubes and resistors were tested and replaced as needed. Wiring and other components were replaced as needed. The radio has beentuned for optimal reception and quality of sound. The cabinet was cleanedinternally with mineral spirits, the external finish restored and lightly waxed. The dial face graphics are crisp and clear. The original knobs werepolished. The grill cloth, if necessary, was replaced with a stunningperiod pattern. Thevintage radio consists of various vacuum tubes, capacitors, resistors, andother electronic components. This radio has been disassembled, cleaned, and allcomponents tested. Non-functioning or suspect components were replaced. Vacuumtubes are similar to light bulbs in that an interior filament heats up insidethe vacuum tube. When the filament burns out, the tube will need to bereplaced. The vacuum tubes installed on this radio have been tested and are ingood working order. The longevity of the tube and its filaments is relatedto the length of time the radio is operated and the frequency of turning theradio power on and off. For instance, a good tube should last 5,000 to 10,000hours. Toprotect your investment in this vintage radio. Vintage radios restored to receive broadcast stations(many Bluetooth enabled). Restoration and Bluetooth installation servicesavailable.